Si que lleva leds, en teoría. Se supone que deben venir enlazadas (receptor emisor), no? En el manual establecen un método de enlace. No lo entiendo bien pero parece que, al contrario de las que he visto, se conecta primero el receptor y después la emisora. Que la emisora, además del botón de encendido tiene un boton para ese enlace. Bueno, no sigo que la cago del todo mi inglés es pésimo.
1. Install the battery in the 2.4G transmitter and shut it down.
2. Insert the matching lines to the channel Bat port of the receiver. (Figure 1)
3. Connect the receiver battery to any one of the channel ports. If the two LEDs are
flashing at the same time, this means the receiver is successfully matched.
4. Press and hold the button on the transmitter, then switch on the power supply.
5. Check the LED on the receiver. If the LED does not flash, it means it is successfully
matched. (This process takes about 10 seconds.)
6. Release the match button on the transmitter. Take out the match line.
7. Install the servo and then do the test.
8. If the test is failed, repeat the above steps.
9. If the test is successful, insert the power supply port into BAT and make the match
completed. (The above steps are only suitable on CopterX 2.4G products.)
[/FONT]
Por cierto, espero que esa electónica sea mejor que la de walkera, por la experiencia que tengo. HiNote se quedaba corto describiéndola con un "pssssss...." Después de un mes en el distribuidor (ya no se ponía en marcha el receptor, ni leds ni nada) me lo devuelven con la electrónica cambiada (receptor 4 en 1). Lo conecto en la tienda y funciona. Lo traigo a casita y me dispongo a volarlo... en la primera batería tuve que conectarle y desconectarle la misma 7 u 8 veces. Finalmente conectó. Me da que se repetirá lo mismo.