Bienvenidos a Helicopteros RC / Radiocontrol
y entonces no nos quedara mas remedio que pecar, por que en el fondo somos unos pecadores
Assembly Kit The Turbulence D3 helicopter is Hirobo’s Competition grade 3D model. This helicopter allows the pilot to perform the most extreme of 3D maneuvers with ease, precision, and repeatability to insure a competitive edge.The SSZ-IV rotor head provides 30° of pitch range with no binding. Cyclic range allows for nearly 9° of deflection. The dampening system is a specialized progressive system that also restricts feathering axle movement to the vertical axis.The standard 2mm thick G10 frames allow for easy access to all major components while providing a superior rigid platform. The minimalist main fuel tank frame lowers vibration transmission to ensure consistent fuel delivery. A 100c header tank to prevent half-tank lean-out and extend flight times is now standard.A new clutch design allows for less setup time and fast engine removal. New CNC cut Delrin gears allow the use of the most powerful of .90-size power plants. The CNC aluminum high torque autorotation unit is also standard equipment. A new cooling fan shroud fully extends over the cooling fins of modern .90-size engines. This shroud is also compatible with the Eagle3 and Freya models equipped when equipped with carbon lower frames. The swash plate control system is an adaptation of the Eagle3 SWM configuration. A hybrid swash plate allows the pilot to change between 120* and 135* geometry without changing major parts.The tail servo is located on the front of the main frame to eliminate fuel soaking and improve fore-aft balance. The rudder linkage has also been strengthened using 5mm aluminum linkage rods.A new tail hub incorporates 5mm axles, larger 5mm ID bearings and stronger blade grips for precise tail control. A carbon fiber vertical tail fin has been included to lower weight and enhance the appearance.Length: 1380mm (54.33”)Engine: .90 sizeMain Rotor Diameter: 1520 – 1600mm (59.85 – 63”) – 690mm-710mm Main BladesTail pipe mount is 40mm lower than current Freya seriesNew SSZ-IV Rotor Head: (2007 3D Masters Champion Rotor Head) Maximum Pitch stroke: 30°New design 2 piece 2mm thick G10 main frame (carbon frame optional)Shaft and clutch can be separated for easier engine maintenanceNew CNC 99T main gear for 8.25:1:4.77 3D ratioHigh-Torque auto-rotation unit standardSimple SWM linkage: Both 120° & 135° can be used with the same partsFront mounted rudder servo:(not on tail boom) with 5mm aluminum linkage rods100cc header tank includedNew cooling fan shroud covers larger .90 size engine heads (compatible with Eagle/Freya Series with carbon lower frames) 5mm improved tail hub shaft, tail grip bearings with new, stronger blade grips (compatible with the Eagle/Freya series) Horizontal tail fin not included or requiredWhite, gel coated FRP Cabin, decals included* Blades, engine, muffler, and electronics not included
