Helicopteros Radio Control - RC - Radiocontrol

Alguien tiene información sobre las funciones escondidas del Governor GV-1 ?
Para saber como són teneis que pulsar las teclas func+ y func- al mismo tiempo y luego encender la electronica, aparecen una funciones escondidas que ni yo mismo sabia que existian. (http://www.helicopterosrc.net/richedit/smileys/YahooIM/106.gif)   
Tambien dice la versión del firmware, en mi caso es la 1.2, no sabia que se podia actualizar pero supongo que solo en manos del servicio tecnico y sus aparatos.

Hola, espero que esto te sirva.

http://www.natew.com/rcheli/frame_main.cgi/html.FutabaSecret (http://www.natew.com/rcheli/frame_main.cgi/html.FutabaSecret)


Menus Ocultos:
Ver 1.20 software version?
PHis 0.6% Proportional something?
IHis 0.8% Integral somthing? history?
G 42%/50% balance can be adjusted 1-for-1 with +/- keys, but
what does G stand for?
Maybe it's Proportional vs. Integral gain balance,
is that what Bob P was needing?
IGa 1.7% Integral Gain?
GDan 00%
GC8->100% not adjustable from front panel - tx maybe?
(I'm wishing I'd had the Tx with me when i was
documenting the GV-1, I suspect the "8" would
vary with one of the input channels...)
GCo- 0%
ICo- 50%
LmHV 20%
GLmt 35% could this be the minimum throttle setting????
LmSt 50%
TAdL 30% travel adjustment low? 30% coincides with Futaba
Tx minimum
TAdH 90% ok, maybe not
Gov ACT switches ACT/INH with data keys: Governor Active /
Inhibited?
Smpl 1Fr sample N frames (of what?)
AVR. 7t average over N passes to determine speed?
FLT. 4n
Dlay 3us Delay (of what?)
OnRv 70% Governor turns on when actual RPM reaches this
percentage of desired RPM
Wait 2Fr skip a couple frames before... hm?
DlUP 3S Delay when raising speed - allow N seconds to
reach new speed
DlDN 5S Delay when lowering speed - allow N seconds to
reach new speed
LDl 100 Fr something-delay, 100 frames?
RAdj INH toggles ACT/INH with data keys
RESET blinking restore factory defaults, probably

Gracias por la info pero como es una información no oficial no pillo casi nada, bueno mejor no tocar nada sin saber, de todas formas te lo agradezco mucho.